Cross section of a CMOS process.
Analog Design Engineer Interview Questions
789 analog design engineer interview questions shared by candidates
Nyquist sampling and aliasing
RC highpass and lowpass circuit.. their magnitude and phase response.
Domande relative alla struttura di circuiti standard ( opamp, bandgap, amplificatori) e ai parametri di progetto ( offset, banda, stabilità). Analisi di suddetti circuiti ed eventualmente di aspetti correlati ( parassiti, layout, ecc ecc).
I was shown an RC circuit. Basically, a first-order low pass filter. I was tasked with explaining it in my own terms.
Draw a simple low pass and high pass filter and draw IV curves of a bjt
1. A required current to be carried was provided. A metal with current density specification was provided. Asked to calculate metal width required to carry the specified current over a particular length to meet a particular voltage drop. Follow up questions based on the above concept varying different parameters like current,length etc. 2. A basic current mirror set up. Asked about short channel effect for the devices in this set up. How the SCE impacted for these devices as current mirror ratio is changed. follow up questions on SCE. 3. Basics of source follower circuit. 4. questions regrding my course work.
They asked about the digital filtering technique and what will be the output if a digital filter will be used for re-construction of original signal from sampled data. like difference between a digital low pass filter and a analog low pass filter
Differential amplifier related question,they have asked,similar to razavi book question
Struttura CMOS Circuiti con induttori e resistenze da analizzare
Viewing 631 - 640 interview questions