KLA Electrical Design Engineer interview questions

I had one interview that was easygoing. The interviewer went over a powerpoint presentation describing the company. He then asked basic personality type of questions, and some basic technical knowledge questions.

The interview process consisted of one phone screening of an hour following with two onsite interviews of 4 hours approximately. The position was for NCG with majorly dealing in finding solutions for PCBs of obsolete legacy KLA products. Phone screening is basically the hiring manager explaining job responsibilities and your willingness for that job role There were two onsite interviews because they want you to meet with each and every member of the group (8 members and the hr) They had asked me to give a technical presentation on a topic falling under Hardware Applications System for 30mins. I gave a presentation on one of my Academic project from SJSU which was about designing a Network on Chip Bus for a Cyclic Check Redundancy module. I would suggest choosing such topics on which you have worked hands on. This helps in all the cross questioning during the presentation and displays your efforts in the project. The first onsite interview along-with the presentation had a tour of the laboratory where the silicon inspection tools were kept followed by interviews with three members of the team. These round of interviews were more based on skills and projects listed in your resume and some basic electrical circuitry concepts. Once you clear the first round they ask to meet the remaining members of the team. In my case, there were three interviewers. This was more technical than the first on-site, focusing on PCB concepts, basic electrical and electronics concepts and how could you fit in the team (contribute to the team). Second onsite